Designed to filter and retain particles of bone which have been suctioned along with standard irrigation during surgery. The graft may be obtained from almost any bony site; examples include dental implant preparation sites, the mandible, maxilla, calvarium, etc. The ilium should not be used as clots will clog this device. The collected graft material can be used either in a wet amorphous form, or a compressed osseous particulate. The drier particulate, which is easier to handle, can be obtained by compressing the collected material in a screen with the titanium plunger. This forces out excess moisture through the screen.

NOTE: The ACE Autografter™ is not a routine suction device; therefore, bleeding should be controlled prior to use.

ACE Autografter™ Start Up Kit
003-4215 ACE Autografter™ Start Up Kit
Included in Start Up Kit, also available individually
•003-4212 ACE Autografter™, for HVAC Tip, Autoclavable
•09-000-24 HVAC Suction Tip, 4mm Tip, 45° Angle, 7”, 18c
•003-4211 Titanium Plunger 4-1/4”, 11cm
•646-2002 Screen Assembly/Basket, Disposable, Sterile, 12cc Capacity10/box

Optionals not included in Start Up Kit
003-4210 ACE Autografter™, both ends connect to suction tubing
96-004-49 Square Titanium Bowl, 12mm Deep, 50 x 50mm
10-002-16 Implant Curette with Round Cups, Ti, 5-1/2”, 14cm
705-4005 Y Connector, 7.5mm I.D., 11.5mm O.D.

Not shown
003-0276 Suction Connection Tubing, Sterile, 1’, 3cm
003-4238 Suction Connection Tubing, Sterile, 3’, .9m , 20/ca
003-4239 Suction Connection Tubing, Sterile, 6’, 1.8m 20/ca

ACe Autografter™ Patent # 5,954,961